Sensitizing LS2 location knock sensors
Thread Starter
11 Second Club
iTrader: (14)
Joined: Nov 2004
Posts: 1,653
Likes: 1
From: Michigan (Macomb or Lansing)
Sensitizing LS2 location knock sensors I have my ls1 knock sensors used on my ls2. They are located on the sides of the block. I have never seen a single degree of knock in a scan.
I know there is a sensitization table in hptuners, however I don't really understand it. Ive jacked the values upwards in certain areas, but i have no idea where they should be set at. Does anyone have a preconfigured table or have any tips to set it up.
Ive heard there was a post about this somewhere on hptuner's forum, but I have been unable to find it.
I know there is a sensitization table in hptuners, however I don't really understand it. Ive jacked the values upwards in certain areas, but i have no idea where they should be set at. Does anyone have a preconfigured table or have any tips to set it up.
Ive heard there was a post about this somewhere on hptuner's forum, but I have been unable to find it.
