454navyss

iTrader: (47)

I have an older HTP cable (VCM suite 1.0), when I tried to download HTP to my computer it said I needed .NET framework v2.0. so I googled it and downloaded it, restarted computer and tried to download HTP again and got the same error message. I have tried deleting the framework and doing everything again but I keep getting the same error.

I did find https://ls1tech.com/forums/pcm-diagn...indow-7-a.html
followed the link and followed the link from the link but I guess Im too dumb to figure it out, can someone explain what I need to do to get HTP to download to my computer so I can start messing my truck up.

454navyss

iTrader: (47)

and I have Windows Vista if it matters

foff667

iTrader: (2)

For those customers that are still using the old serial interfaces use MSI edit to delete the net framework check in the installer, msi editor & instructions on how to do this can be found here http://www.hptuners.com/forum/showpo...6&postcount=22

Because serial interfaces stored the licenses in the software it is imperative to use YOUR software and not the MPVI software that is posted in this thread.

454navyss

iTrader: (47)

ok, i'll try that. thank you

454navyss

iTrader: (47)

I guess Im dumber than i thought, I still cant figure this out

foff667

iTrader: (2)

You need to download/save YOUR software from YOUR customer login page.

Open msi editor

Open the file you saved in msi editor

delete the net framework check

save the file

close msi editor

run the newly saved download.

done.

OldCobraGuy

iTrader: (2)

Can you emulate XP and get past that as well?