Performance mode
10-24-2012, 10:43 PM
#1
TECH Apprentice
Thread Starter
iTrader: (12)
Join Date: May 2011
Location: dallas tx
Posts: 309
Likes: 0
Received 0 Likes
on
0 Posts
Performance mode So doing a little bit of tunning I notice their is a performance mode on hp tuner has anyone done the performance mode switch and does it do anything special I know u have to 2 Wire a momentary ground switch to pin J1-71 on the PCM (the blue connector) to trigger it
10-25-2012, 06:31 PM
#4
It's however you tune it.
There are two sets of trans tables in the pcm .
Both can be customized to suit you.
I put the switch in my car and upped the line pressure
in lower areas that would be annoying all the time.
No TCC and shifts quite late. So I hit the switch the converter unlocks and
it drops down a gear. If that fails to make enough noise I open the cut-out.
There are two sets of trans tables in the pcm .
Both can be customized to suit you.
I put the switch in my car and upped the line pressure
in lower areas that would be annoying all the time.
No TCC and shifts quite late. So I hit the switch the converter unlocks and
it drops down a gear. If that fails to make enough noise I open the cut-out.
