Help narrowing down dead spot in my throttle
#1
Teching In
Thread Starter
Join Date: Feb 2006
Location: sioux city, ia
Posts: 45
Likes: 0
Received 0 Likes
on
0 Posts
Help narrowing down dead spot in my throttle
Having trouble narrowing where my dead spot in my motor is coming from
.. at idle if I try to Rev it quick it just falls on its face
Run down what it is..
Forged 370 ci 10:5.1
Ported 317s
Vic jr
Accufab 4150
Fic 525 injectors
Ls7 lifters
Not sure if it's a fueling issue, something in computer/electrical, or motor issue
Just put a new custom grind cam in specd to motor to see if that solved it and it didnt.. I can take video if needed .. need some guidance. . Thanks guys...
This is a new build so been this way since it went together not all the sudden
.. at idle if I try to Rev it quick it just falls on its face
Run down what it is..
Forged 370 ci 10:5.1
Ported 317s
Vic jr
Accufab 4150
Fic 525 injectors
Ls7 lifters
Not sure if it's a fueling issue, something in computer/electrical, or motor issue
Just put a new custom grind cam in specd to motor to see if that solved it and it didnt.. I can take video if needed .. need some guidance. . Thanks guys...
This is a new build so been this way since it went together not all the sudden
#6
On The Tree
Geezer - I think everything is on the feed and the return line comes out the bottom of the regulator.
This works OK but does not circulate the fuel in the rails. Not circulating the fuel in the rails means the only way for air to get out is through the injectors.
OP - I asked before about engine management I meant what ECU/PCM are you using?
And how are you tuning it?
This works OK but does not circulate the fuel in the rails. Not circulating the fuel in the rails means the only way for air to get out is through the injectors.
OP - I asked before about engine management I meant what ECU/PCM are you using?
And how are you tuning it?
Last edited by RixTrix; 06-29-2015 at 07:48 AM.