O2 B2s1 & b2s2 not ready?
Thread Starter
TECH Apprentice
Joined: May 2010
Posts: 361
Likes: 0
O2 B2s1 & b2s2 not ready? So my car had rear O2 sims on it, I unplugged them and deleted the proper stuff in dtcs. But now my bank 2 s1 and s2 say not ready in red on my status bit.
The O2 voltage is reading on both tho but very low for b2s1 compared to b1s1.
Bank1 s1 and s2 say ready in green on status bit.
What's going on here I already checked to see if and wires were burnt or bad connections everything seemed fine.
What am I missing couldn't turn anything up searching
The O2 voltage is reading on both tho but very low for b2s1 compared to b1s1.
Bank1 s1 and s2 say ready in green on status bit.
What's going on here I already checked to see if and wires were burnt or bad connections everything seemed fine.
What am I missing couldn't turn anything up searching
