Dyno LS specialist Turner
Thread Starter
Teching In
Joined: Jan 2015
Posts: 48
Likes: 0
Dyno LS specialist Turner Spun bearing On original LS-1 in 98 Camaro SS. Had it jerked out. Bought an LS-3 377/480 hot cam crate and stuck in. Making 444 pounds of torque at 4300 RPMs at rear wheel. I don't like that. I'm looking for someone with a Dyno, and someone that you guys can trust and put the good word in to me, to do a cam swap, tune and a pull. Need someone that really knows their **** with the LS Motors. Want the torque to peak sooner. Would definitely leave the cam choice up to whoever I hope you guys can steer me too. Thanks for everyone's help ahead of time. I live about 70 miles south of Pittsburgh. Would not mind driving, if the job can be done in a couple days, just get a hotel room. Went to a place in Masontown. Got treated very well. But told me mustangs was his specialty, knew about LS motors, but self-admitted to me that LS Gm's wasnt his cup of tea.I want someone that specializes in LS motors. Once again any help with steering me in the right direction would be greatly appreciated.
Last edited by Bohnseye; May 30, 2016 at 02:26 AM. Reason: Numbers should've been rear wheel
