Adding meth to whipple
Thread Starter
Joined: Nov 2001
Posts: 818
Likes: 1
From: Hamilton/Ontario
Adding meth to whipple Hi All.
I'm looking to add Meth to my holley terminator x, LSx, Whipple, M6 setup.
Is there a rule of thumb with how much timing to add with how much Meth? It's an AEM controller. Should I maybe be asking them? I was going to turn on the Meth at about 5 psi along with my 2nd fuel pump.
I was thinking of just starting a single small jet, bumping timing a tiny bit and see how it reacts.
Any suggestions would be appreciated.
I'm looking to add Meth to my holley terminator x, LSx, Whipple, M6 setup.
Is there a rule of thumb with how much timing to add with how much Meth? It's an AEM controller. Should I maybe be asking them? I was going to turn on the Meth at about 5 psi along with my 2nd fuel pump.
I was thinking of just starting a single small jet, bumping timing a tiny bit and see how it reacts.
Any suggestions would be appreciated.
Hey I am just going to say, I am new to spraying meth also. I would say, I wouldn't turn on both a second pump, and meth at the same time. In the event you have a following tuning issue, it just makes it more complicated to diagnose imo.
I am looking at possible using the Terminator X to control the meth on a Procharger setup. I'm sure I could do that 3 or 4 different ways in the software, I just haven't looked at it close enough yet.
I am looking at possible using the Terminator X to control the meth on a Procharger setup. I'm sure I could do that 3 or 4 different ways in the software, I just haven't looked at it close enough yet.
