Which PCM Should I use?
#1
Launching!
Thread Starter
Which PCM Should I use?
So I'm converting my DBW to a SBC setup and I have 2 PCMs. The PCM that I have been running is set up for my DBW 6.0 LQ9 setup. The other PCM I have came out of a junkyard truck which was DBC. Would I be better off putting a DBC tune in my current PCM, or would it be easier to try out my other PCM which was already set up for DBC?
#2
TECH Fanatic
Too much missing info here. Some DBW PCM hardware does NOT have the printed circuit board capability to support a DBC setup - needs the IAC chipset, IIRC. What are your PCM Hardware Service Numbers? Hardware, NOT Service Numbers.
Rick
Rick
#3
Launching!
Thread Starter
You are right, I need to double check the numbers. I know which ones work based on the info on LT1 swap. It is a red/blue so most likely will.
#5
Launching!
Thread Starter