term-x-max vss signal tap
term-x-max vss signal tap for any of the guru's out there that might know this, can I tap a signal from my existing term-x- vss to run an aftermarket dash without causing interference/signal loss with my term x ecm? I built a digital dash for my 66 Buick Special and would really like the speedo to work without tapping an output from the ecm. If I can just rob some signal from the VSS it'd be perfect. The aftermarket setup runs off of a standard 8,000ppm signal so if I wouldn't get too much signal loss using the dash AND the term x I'm guessing it will work? Thanks, Bill
for any of the guru's out there that might know this, can I tap a signal from my existing term-x- vss to run an aftermarket dash without causing interference/signal loss with my term x ecm? I built a digital dash for my 66 Buick Special and would really like the speedo to work without tapping an output from the ecm. If I can just rob some signal from the VSS it'd be perfect. The aftermarket setup runs off of a standard 8,000ppm signal so if I wouldn't get too much signal loss using the dash AND the term x I'm guessing it will work? Thanks, Bill
Andrew
I know I can use that output if needed but was hoping to save it for some possible expansion later down the road if I decide to boost this motor. I was really hoping that the signal was strong enough to run both the ECM for the trans as well as give me a signal to my dash. I bought a stub harness from Current Performance and heard from several folks that it will work. Fingers are crossed for now! Thanks!!
I know I can use that output if needed but was hoping to save it for some possible expansion later down the road if I decide to boost this motor. I was really hoping that the signal was strong enough to run both the ECM for the trans as well as give me a signal to my dash. I bought a stub harness from Current Performance and heard from several folks that it will work. Fingers are crossed for now! Thanks!!
Andrew