Ve table ?
02-26-2005, 12:42 PM
#1
11 Second Club
Thread Starter
Join Date: May 2004
Location: Va. beach,Va
Posts: 226
Likes: 0
Received 0 Likes
on
0 Posts
Ve table ? I've read the sticky on v-e tables 
and most of it math wise I am very rusty with. I am using atap for a scanner and needed to know is it as simple as whatever the gm/sec(?) reads for a specific rpm to replace the values in the ve tables with the same??? I've done so and gas mileage/response seems to have improved. Also raising those values tend to lean the mixture?Since doing this my ltft have gone to positive should I be in the maf tables to correct and raising those values would it not richen the fuel?I know there are many ways to accomplish the same objective. Am I on the right path?
and most of it math wise I am very rusty with. I am using atap for a scanner and needed to know is it as simple as whatever the gm/sec(?) reads for a specific rpm to replace the values in the ve tables with the same??? I've done so and gas mileage/response seems to have improved. Also raising those values tend to lean the mixture?Since doing this my ltft have gone to positive should I be in the maf tables to correct and raising those values would it not richen the fuel?I know there are many ways to accomplish the same objective. Am I on the right path? 