pcm injector drivers
#1
TECH Junkie
Thread Starter
iTrader: (2)
Join Date: Oct 2004
Location: Cornelius, NC
Posts: 3,473
Likes: 0
Received 0 Likes
on
0 Posts
pcm injector drivers
Can someone outline the two types of injector drivers and does GM use the same type in all there vehicles. Specifically wondering about the 5.3 vs the 8.1
#3
TECH Enthusiast
iTrader: (8)
Join Date: Feb 2004
Location: In my garage
Posts: 579
Likes: 0
Received 0 Likes
on
0 Posts
I'm going to take a guess at what your mean:
Does GM use saturated or peak /hold drivers for their LSx and Vortech lines?
Saturated in all as far as I know. However, I have never peaked under the hood of a 8.1.
Does GM use saturated or peak /hold drivers for their LSx and Vortech lines?
Saturated in all as far as I know. However, I have never peaked under the hood of a 8.1.
#4
wrencher
iTrader: (2)
Join Date: Aug 2002
Location: Chicagoland
Posts: 4,762
Likes: 0
Received 0 Likes
on
0 Posts
Peak & hold & current limited/saturated. The latter is what is used on LSX & most motors that I know of. The peak & hold is usually used on low resistance injector circuits.
There are a couple more variations I think, but I dont think GM uses them.
There are a couple more variations I think, but I dont think GM uses them.
#6
TECH Enthusiast
iTrader: (8)
Join Date: Feb 2004
Location: In my garage
Posts: 579
Likes: 0
Received 0 Likes
on
0 Posts
P/H injectors have bigger coils then saturated injectors. P/H are more linear, have a wider flow range, and are less effected by voltage drop. Saturated are less expensive.
Saturated injectors will work on a P/H driver. But not the opposite.
Why are you interested in P/H?
Saturated injectors will work on a P/H driver. But not the opposite.
Why are you interested in P/H?