Wideband reading indcorrectly....

Reply Subscribe

Thread Tools

Search this Thread

Oct 19, 2005 | 12:00 AM

JetVette

Thread Starter

Staging Lane

iTrader: (1)

Joined: Nov 2004

Posts: 59

Likes: 0

Wideband reading indcorrectly....

Ok, So I finished wiring up the LC-1 wideband and dyno tune gauge. Its working but seems to think 7.x is 0 and somewhere around 22.x:1 is stoich. I talked with the guy at dyno tune and he said that they pre calibrate all there widebands before they send em out so you dont need to. Is there any way to zero it out? Its a pain to get to all the wires and sensor because of the placement. Its a C5 so everything is above the tunnel plate (37 bolts). Any help?

Oct 19, 2005 | 06:48 AM

foff667

LS1TECH Sponsor

iTrader: (2)

Joined: Jul 2003

Posts: 7,986

Likes: 3

From: Clermont, FL

i dunno about the lc1 but my lm1 out put had to be changed so i could use it with hptuners...i had to attach it to my laptop & use their software to fix it and set it up.

Oct 19, 2005 | 06:54 AM

TAQuickness

TECH Junkie

iTrader: (28)

Joined: Jan 2004

Posts: 3,250

Likes: 1

From: Houston

You should have a data cable (serial) to connect to the LC-1 controller. Install this cable, if not allready, and you can then use your laptop to re-calibrate the LC-1 outputs. You may also need to perform the free air calibration again.

I don't have the link to Innovative's web site, but all the latest documentation can be downloaded from their web site

Reply Subscribe

Reply Share

First
Prev
1 / 1
Next
Last