99 WS6 w/ A4

On one of the tabs there is a spot to change the max RWTQ value. The default is 350. Does anybody know what this is for? Is it a limiter? Will bumping it up allow more TQ transmission by taking out some TQ management? Anyone know?

 

This will make the computer take out timing to reduce power when shift occurs and RWTQ is higher than the inserted value. I assume this is to save the transmission.

You won't like the effect if you are putting out much more torque than this value.

Mine is set to 600. <img src="gr_grin.gif" border="0">

 

Yep, this is the breakpoint at which calculated engine output torque triggers the torque management protocol. Your best bet would be to log a run, look at the greatest delivered torque value, and set the value in this table to ~100ft-lbs higher.