computer guru's come on in
Thread Starter
TECH Apprentice
Joined: Nov 2001
Posts: 355
Likes: 0
From: Cape Coral,FL
computer guru's come on in Ok, I decided to get my setup dialed in and when i put it on autotap, it was pig rich(910-.930 o2's). I have bein running throuh a catback , but this is when i took off my cutout. Now, how long does it take the Computer to realize the new found cutout is off? I have autotap and a translator and was wondering if i dial in the catback and then with the cutout off, can i just switch the settings, or will i have to let the computer relearn itself? I had the base set at 2 and the wot set at 3, my ltrims are constanly wack, at idle they would be at 0, then at cruise one would be at say -1.3 and the other at +1.3, any info would be greatly appreciated...
<small>[ April 22, 2002, 10:56 PM: Message edited by: blazinredls1 ]</small>
<small>[ April 22, 2002, 10:56 PM: Message edited by: blazinredls1 ]</small>
Re: computer guru's come on in It is not uncommon for side to side LTRIMs to vary by 3%. Consistent larger variations (e.g. over 5%) would indicate a potential problem on one side.
BTW, LTRIMs often change as you drive and utilize fuel trim cells, a range of LTRIMs of +/- 5% is not really whack in my book. . I wouldn't worry much about your base and just tweak your WOT.
BTW, LTRIMs often change as you drive and utilize fuel trim cells, a range of LTRIMs of +/- 5% is not really whack in my book. . I wouldn't worry much about your base and just tweak your WOT.
