Question on O2 sensors and Autotap
#1
TECH Enthusiast
Thread Starter
iTrader: (1)
Join Date: Nov 2001
Location: Rochester, Michigan
Posts: 596
Likes: 0
Received 0 Likes
on
0 Posts
Question on O2 sensors and Autotap
This morning I finally got Autotap V2 to work. I just loaded a few parameters to watch and see what it was going to do. One of those parameters was Oxygen Sensor B1S2. I really didn't drive all that far, may 10 miles, but I watched this thing all the way and it never varied from 99.2%. I loaded all four of the O2 sensors and they all fluctuated all over the map, but this one stayed at 99.2%. Could this be a fluke, bad O2 sensor or what? I had the car over at SLP last Wednesday and they scoped and scoped and proded and found nothing. Said the car was running a little lean, but otherwise nothing. (This was done due to the lack of horsepower produced by the LT's they installed.) I think I'm going to try the same thing tomorrow, but I'm going to use V1.1 of autotap and see what that does. Does anybody have any ideas?