What should you do using LS1 Edit after removing cats?
Thread Starter
TECH Apprentice
Joined: Dec 2001
Posts: 351
Likes: 0
From: CA
What should you do using LS1 Edit after removing cats? I assume you disable the error codes (which ones?) but is there any where else that the 2nd set of O2 sensors are used in calculating fuel delivery or anything? Is it better to leave the O2 sensors just hanging in air or to just stick it back into the pipe even without the cat?
TECH Regular
Joined: Nov 2001
Posts: 499
Likes: 0
From: Clarkston
Re: What should you do using LS1 Edit after removing cats? Correct, all you need to do is to delete the rear O2 codes. Scroll through the list and turn off any codes referencing sensor 2 on either bank.
They are only used for cat eff and nothing else.
Good luck!
Mark
They are only used for cat eff and nothing else.
Good luck!
Mark
Thread Starter
TECH Apprentice
Joined: Dec 2001
Posts: 351
Likes: 0
From: CA
Re: What should you do using LS1 Edit after removing cats? Do you know which codes those are exactly?
And I just read about this CAT over temp option as well. Sounds like there was something else that those sensors did.
And I just read about this CAT over temp option as well. Sounds like there was something else that those sensors did.
