Fuel Injector Flow Rate Table Axis
Thread Starter
Staging Lane
Joined: Aug 2002
Posts: 55
Likes: 0
From: Plano, Texas
Fuel Injector Flow Rate Table Axis The x-axis values in the fuel injector flow rate table (LS1Edit) are displayed on the graph view as manifold vacuum. In the table view, the values range from 0 kPa to 80 kPa.
If 80 kPa converts to 23.62 inHg (can someone verify the conversion)? Are the intake MAP values we are recording (Ease/AutoTap), which can range to 30+, supposed to correspond to the x-axis values in the flow rate table? If so, shouldn't the flow rate table have a few more columns?
If 80 kPa converts to 23.62 inHg (can someone verify the conversion)? Are the intake MAP values we are recording (Ease/AutoTap), which can range to 30+, supposed to correspond to the x-axis values in the flow rate table? If so, shouldn't the flow rate table have a few more columns?
Oz Director
Joined: Nov 2001
Posts: 208
Likes: 0
From: Australia
Re: Fuel Injector Flow Rate Table Axis 80kPa is 23.62399Hg.
You best to get this answered in the www.ls1edit.com forum.
Ken would know why is only goes to 80kPa.
You best to get this answered in the www.ls1edit.com forum.
Ken would know why is only goes to 80kPa.
