2005 LS2 tuning SD-trouble codes
Thread Starter
Launching!
Joined: Nov 2001
Posts: 254
Likes: 0
From: NC
2005 LS2 tuning SD-trouble codes I'm running in SD by setting the MAF overflow to a low number. Car runs great, and I've got my VE table nearly dialed in, however it is setting some electrical codes. I shut off the lights for P0101, 0102, and 0103, but I'm getting a "service electrical system" and "traction control disabled" readings.
I don't know if this is specific to the LS2, or if previous LSX engines did this. I had hoped to leave it MAFless, but if I can't figure this out, I'll turn it back on after dialing the VE in.
I wonder if physically disabling the MAF, or setting it to fail another way, would work better.
btw, tuning with LS2edit. Any advice appreciated.
I don't know if this is specific to the LS2, or if previous LSX engines did this. I had hoped to leave it MAFless, but if I can't figure this out, I'll turn it back on after dialing the VE in.
I wonder if physically disabling the MAF, or setting it to fail another way, would work better.
btw, tuning with LS2edit. Any advice appreciated.
