Code Problems!
Thread Starter
11 Second Club
iTrader: (3)
Joined: Nov 2004
Posts: 274
Likes: 0
From: Tulsa, Oklahoma
Code Problems! Ok so i've got a 98Z28, and are notorious for the knock sensors failing on them, So i had a SES light that came up on me saying they were bad,..so i go out and get the better newer model knock sensors and harness's for it and take the intake off, take the old ones out, new ones in...splice the new harness into the old wire, put the intake back on and connect everything back up and now im getting a P0342 Code which is saying that the voltage signal from my cam position sensor A is too low for the current engine operating conditions & P0327 code which is also a voltage signal from knock sensor 1 is too low for current engine operating conditions.
TTT... I just finished my H/C/Intake install, and upon my first couple startups tonight (startup, idle, turn off, restartup, etc.) I also have popped the P0342 code.
Any resolution to your issue???
Any resolution to your issue???
ya me too. didn't do it last year with my other cam install. I haven't had any real time to come to a solution the factory manual has 36 steps to go through It drives fine to codes go to start it wont start at first. Im just wondering if I screwed up the exciter ring somehow ???? Cam went in fine no hang ups nothing.
