Would this be a tuning problem?
03-23-2006, 07:48 PM
#1
11 Second Club
Thread Starter
iTrader: (20)
Join Date: Mar 2005
Location: J.C.
Posts: 575
Likes: 0
Received 0 Likes
on
0 Posts
Would this be a tuning problem? I put a cam in my car last Friday *Torquer v.2* and after that my car will not shift into 1st or OD at times. If I come to a stop it starts off in second then will shift to third but wont even lock up. But then after awhile it will start using them again. Would this be a tuning problem? If so could some body tell me how to fix it using HP Tuners?
Thanks in advance,
Devon
Thanks in advance,
Devon
03-24-2006, 01:05 AM
#4
10 Second Club
iTrader: (5)
Join Date: Aug 2004
Location: Missouri
Posts: 272
Likes: 0
Received 0 Likes
on
0 Posts
The misfire detection cause all sorts of problems. Did you scan to see if it's throwing any codes?
Go into engine diagnostics under the Misfire tab. Set misfire detection max temp to 34 and min to 19. That should help out.
Go into engine diagnostics under the Misfire tab. Set misfire detection max temp to 34 and min to 19. That should help out.
03-24-2006, 05:49 PM
#6
11 Second Club
Thread Starter
iTrader: (20)
Join Date: Mar 2005
Location: J.C.
Posts: 575
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by CrazyCarl
The misfire detection cause all sorts of problems. Did you scan to see if it's throwing any codes?
Go into engine diagnostics under the Misfire tab. Set misfire detection max temp to 34 and min to 19. That should help out.
Go into engine diagnostics under the Misfire tab. Set misfire detection max temp to 34 and min to 19. That should help out.