Using Gary's "HP Tuners Basic Tuning 101" on an LS1
Using Gary's "HP Tuners Basic Tuning 101" on an LS1 I know this was written for the 3800's but think its ok to use most of the principles/procedures (unless explicitly stated) to tune the LS1's?
Tonight I finally got my laptop ready, and am going to go get some logging done and wonder if I can operate of that tutorial.
It seems to match all the other tutorials I've read from the stickies for the most part.
So my plan tonight is to
1) Set MAF Code
2) Reset fuel trims
3) Set "Hot power enrich enable % TPS threshold Vs. RPM to 100's through 6400 RPM (I think I have been getting into PE in the last couple, i didn't realize the threshold was only around %64 on my stock tune)
4) Reset Fuel Trims and log for about 30-40 minutes
After that I'll work on the tables using that guide and other resources.
Does that sound like an OK plan?
Sorry for the lame newbo questinos, just wanna get this right sometime soon.
Thx folks
DJ
Tonight I finally got my laptop ready, and am going to go get some logging done and wonder if I can operate of that tutorial.
It seems to match all the other tutorials I've read from the stickies for the most part.
So my plan tonight is to
1) Set MAF Code
2) Reset fuel trims
3) Set "Hot power enrich enable % TPS threshold Vs. RPM to 100's through 6400 RPM (I think I have been getting into PE in the last couple, i didn't realize the threshold was only around %64 on my stock tune)
4) Reset Fuel Trims and log for about 30-40 minutes
After that I'll work on the tables using that guide and other resources.
Does that sound like an OK plan?
Sorry for the lame newbo questinos, just wanna get this right sometime soon.
Thx folks
DJ
