using atap
Thread Starter
Launching!
Joined: Jul 2005
Posts: 279
Likes: 0
From: Sweden (Malmö)
using atap I have a autotap and i want to see that everything is ok with the car. What parameters should i look at? And what should they be at? What else can you do?
I have mafends and a maft + catback and lid
I have mafends and a maft + catback and lid
Thread Starter
Launching!
Joined: Jul 2005
Posts: 279
Likes: 0
From: Sweden (Malmö)
2.04 version. So if i want to check the tune on the car. What should i look at?
would be greatly apperciated if anyone could tell me how to do, and i dont really understand how to read the numbers....
would be greatly apperciated if anyone could tell me how to do, and i dont really understand how to read the numbers....
Last edited by Doski; Jul 1, 2006 at 03:45 AM.
Thread Starter
Launching!
Joined: Jul 2005
Posts: 279
Likes: 0
From: Sweden (Malmö)
anyone...please. I drove a little yesterday but i dont understand the loggdata.
only thing i know is that o2 should be 890mv at wot. i think mine showed 40???
only thing i know is that o2 should be 890mv at wot. i think mine showed 40???
Last edited by Doski; Jul 4, 2006 at 04:40 AM.
it's been a while since i played with atap. you might try logging fewer parameters. IIRC, ataps sample rate reduces dramatically with each additional parameter selection.
In otherwords, if you had just a quick WOT, atap may not be scanning fast enough to capture the WOT run.
In otherwords, if you had just a quick WOT, atap may not be scanning fast enough to capture the WOT run.
