LC1 Sensor dead?
Thread Starter
TECH Veteran
iTrader: (12)
Joined: Dec 2004
Posts: 4,354
Likes: 0
From: Rockville, MD
LC1 Sensor dead? ok, ive solved some grounding issues but now have a completely different one. i have programmed my n/b and w/b to 1/6th a second and everything, the issue is that im getting between 17-23/26mv and a false 7.XX:1 afr. it doesnt chae much at all when revved so i dont think its the formula its using either. i could try a custom LC1 PID and/or a recalibration. what do you think?
PS- it has read fine in the logworks, im wondering if the wire got melted somewhere too..
PS- it has read fine in the logworks, im wondering if the wire got melted somewhere too..
Thread Starter
TECH Veteran
iTrader: (12)
Joined: Dec 2004
Posts: 4,354
Likes: 0
From: Rockville, MD
its reading .005 volts raw voltage. :confsused:
but reads 20:1 afr(perfectly fine) in logworks. ill check the n/b wiring in the morning.
but reads 20:1 afr(perfectly fine) in logworks. ill check the n/b wiring in the morning.
Last edited by Wnts2Go10O; Jun 28, 2006 at 09:22 PM.
Thread Starter
TECH Veteran
iTrader: (12)
Joined: Dec 2004
Posts: 4,354
Likes: 0
From: Rockville, MD
n/b sim wire setup is fine. raw voltage stays at or around .005 volts from wht hpt says but reports to logworks fine. im wondering if i change where my power comes from if itd maybe change?
Thread Starter
TECH Veteran
iTrader: (12)
Joined: Dec 2004
Posts: 4,354
Likes: 0
From: Rockville, MD
Originally Posted by oange ss
LogWorks reads directly from the sensor bypassin the A/D converter all together...sounds like the controller is bad or rethink wiring
