CASE learn, did it work?
CASE learn, did it work? I was performing the CASE learn function on HPTuners earlier today. I am not quite sure I performed it correctly. This is what happened:
I would hit the "begin" button and it would tell me to gradually increase RPM, I did it exactly as the instructions said, I was even holding the brake as told. As I was bringing the RPM up, around about 3000 RPM it would say "TPS too high", and "RPM to high". I dont think it ever completed a whole learn cycle. Why is it doing this? What am I doing wrong?
I would hit the "begin" button and it would tell me to gradually increase RPM, I did it exactly as the instructions said, I was even holding the brake as told. As I was bringing the RPM up, around about 3000 RPM it would say "TPS too high", and "RPM to high". I dont think it ever completed a whole learn cycle. Why is it doing this? What am I doing wrong?
I've done the test 3 times on my M6, all successful and never saw those codes.
Basically at 4K (or close) it shuts off like a rev-limiter and says relearn complete.
Maybe try the HPTuners.com/forum website? Try it without the brake? Reboot the laptop and car (by unhooking the battery for 10 minutes)?
Basically at 4K (or close) it shuts off like a rev-limiter and says relearn complete.
Maybe try the HPTuners.com/forum website? Try it without the brake? Reboot the laptop and car (by unhooking the battery for 10 minutes)?
