HPT and DynoJet wideband?
Thread Starter
TECH Enthusiast
iTrader: (13)
Joined: Nov 2001
Posts: 607
Likes: 0
From: Chattanooga,TN
HPT and DynoJet wideband? OK, I must be missing something. I have read all the information I can find on the DJ WB, but I am still having problems getting it to read correctly in HPT. It keeps showing 11.5V and will go up to about 12.5V when I push the throttle with the car off. I am using a butane lighter (just the gas) at the sensor, and the guage is sweeping, but I can not get it to change in HPT.
I used the preset DJ WB configuration in HPT, what else to I need to do?
Thanks,
Kevin
I used the preset DJ WB configuration in HPT, what else to I need to do?
Thanks,
Kevin
Thread Starter
TECH Enthusiast
iTrader: (13)
Joined: Nov 2001
Posts: 607
Likes: 0
From: Chattanooga,TN
FYI
To connect Dynojet Wideband to HPTuners:
White wire with the yellow stripe goes to A/D input pin #1
Black wire with gray stripe and white wire with green stripe goes to ground pin #5
To connect Dynojet Wideband to HPTuners:
White wire with the yellow stripe goes to A/D input pin #1
Black wire with gray stripe and white wire with green stripe goes to ground pin #5
Thread Starter
TECH Enthusiast
iTrader: (13)
Joined: Nov 2001
Posts: 607
Likes: 0
From: Chattanooga,TN
Originally Posted by foff667
thanks SS...I added it to the sticky over on the hpt forum 
No problem, that will probably be the only thing I can contribute for a while until I get this tuning stuff figured out. LOL
