O2 reading problems?
03-03-2007, 07:43 AM
#1
Launching!
Thread Starter
iTrader: (7)
Join Date: Nov 2001
Posts: 220
Likes: 0
Received 0 Likes
on
0 Posts
O2 reading problems? I have been through 3 02s on bank 2 sensor1 in the past couple of months.I'm starting to think that its not the O2 that keeps going bad.Last night the car started running like **** again so I hooked up Autotap.Bank 2 sensor1 was reading .000 the other O2 was reading fine.As I drive the car around and watch the reading every once in a while the O2 will start reading fine and the car will run fine.I have checked the connectors for corrosion and they look fine.Could I have a wiring problem or just bad luck?
Last edited by ls2formula; 03-03-2007 at 08:16 AM.
03-03-2007, 08:31 AM
#2
FormerVendor
Join Date: May 2006
Posts: 187
Likes: 0
Received 0 Likes
on
0 Posts
Did you ever try swapping the O2's before buying a new one? That would confirm your suspicion. Look here for various descriptions of Bank 2 errors. Most links have good diagrams of the actual circuit and diagnostic steps that will help determine whether or not you have a wiring problem. I would start with this one.
