reading injector duty cycle
03-18-2007 | 10:08 PM
#2
two ways
a. open the chart view..its in there by default if your using the latest version...been there for a while but not sure when it started
or
b. just log it in the table display...its in the custom pid's portion of the tree.
since IDC is a calculation you must be logging the sensors/PID's it is calculated from ie RPM, injector pulse width.
a. open the chart view..its in there by default if your using the latest version...been there for a while but not sure when it started
or
b. just log it in the table display...its in the custom pid's portion of the tree.
since IDC is a calculation you must be logging the sensors/PID's it is calculated from ie RPM, injector pulse width.
