PLX Wideband pinout needed!!!
#1
11 Second Club
Thread Starter
iTrader: (39)
Join Date: Jan 2003
Location: NW Chicago Subs
Posts: 3,321
Likes: 0
Received 0 Likes
on
0 Posts
PLX Wideband pinout needed!!!
Hi everyone! I goofed up! I am trying to shorten my wideband cable and noticed after the fact that there is 2 white wires and do not know which goes where. Can someone help me out? Maybe someone has one that can chase the wires and let me know which whites go to which pins on the connectors?
TIA
TIA
#2
not sure if this helps...one or the other might be analog wb,or nb voltage...
http://www.plxdevices.com/Installati...UsersGuide.pdf
http://www.plxdevices.com/Installati...UsersGuide.pdf
#3
11 Second Club
Thread Starter
iTrader: (39)
Join Date: Jan 2003
Location: NW Chicago Subs
Posts: 3,321
Likes: 0
Received 0 Likes
on
0 Posts
I tried that document. Not detailed enough. Thanks though. I am guessing they are for the heater in the O2 and it does not matter which way they are connected, but I want to be sure. These things are too expensive to take a guess at it.
#5
FormerVendor
iTrader: (73)
Join Date: Nov 2005
Location: Baton Rouge, LA
Posts: 4,072
Likes: 0
Received 0 Likes
on
0 Posts
Actually if you swapped the two whites around all you would notice is a real rich reading at WOT, the whites control the heating of the sensor. If you would notice this simply swap the white wires around..
You cant actually harm the unit itself from mis-wiring the white wires.
I also PM'd you my cell number just incase you had anymore questions.
Derek
You cant actually harm the unit itself from mis-wiring the white wires.
I also PM'd you my cell number just incase you had anymore questions.
Derek