Tach not working?
#1
TECH Enthusiast
Thread Starter
iTrader: (3)
Join Date: Apr 2002
Location: Houston tx
Posts: 685
Likes: 0
Received 0 Likes
on
0 Posts
![](https://ls1tech.com/forums/images/ranks/ls1tech10year.png)
![Default](https://ls1tech.com/forums/images/icons/icon1.gif)
Pulled my hooker long tubes and put the stock ones back in. Pulled the K member off to do this installed every thing back on and the tach does not work. I know what wire it is comeing off the computer and i use a meter to test it and there is no signal. WHat could it be the only wires i unded was the ones needed to remove k member.
#3
TECH Fanatic
iTrader: (18)
Join Date: Nov 2002
Location: norristown PA
Posts: 1,067
Likes: 0
Received 0 Likes
on
0 Posts
![](https://ls1tech.com/forums/images/ranks/ls1tech20year.png)
![Default](https://ls1tech.com/forums/images/icons/icon1.gif)
my tach also stopped working, and it threw a P0345, something to do with the Camshaft position sensor, do you think my harness is bad? because the tach will occasionally work for a few seconds, then crap out.
also, what side of the head is the harness on, and where are the grounds?
thanks for the help
jimmy
also, what side of the head is the harness on, and where are the grounds?
thanks for the help
jimmy
#4
TECH Enthusiast
Thread Starter
iTrader: (3)
Join Date: Apr 2002
Location: Houston tx
Posts: 685
Likes: 0
Received 0 Likes
on
0 Posts
![](https://ls1tech.com/forums/images/ranks/ls1tech10year.png)
![Default](https://ls1tech.com/forums/images/icons/icon1.gif)
The car runs fine no SES light or anything worked before i removed the K Member i did not tuch any wires except the stater wires, oxygen sensors, and cam timing sensor. I have no idea what it could be.