Please could you tell me step by step how to shut off p0751 and p0757 with HPT.

Tranny goes in limp mode.
Where do i go and what do I clic.

I've established that it is due to the looseness of my Vig 3800, it used to do that rarely, but now it is more often and a pain the ***.

Thanks,
Mark

 

pm performabuilt..... frank might know

 

Go into your editor and pull up your tune. Click on Engine Diagnostics. You then click DTC's. Go down until you hit the code your looking for. Under SES Enable you un-check the code. Under Error mode where it says 0-MIL on First Error, click on it and an arrow menu will appear. Go and select 3 - No Error Reported. When your done, flash calibration only and your done...................

 

Thanks Dmoney,

I really should take a course in EFI 101, that is where I can tell I used to be old school