ECM seals
Thread Starter
TECH Enthusiast
iTrader: (2)
Joined: Aug 2008
Posts: 617
Likes: 0
From: Alberta, Canada
ECM seals Hey guys, I tried looking for a thread about this, but I couldnt find one so Ill ask. I took the connectors off my ECM and sent the harness to Speartech. My question is about the small thin orange seals that are between the connectors and then ECM, they are all flimsy and not staying in place around the perimeter of the 'flange', and they dont stay when I try to position them. Has anyone had this issue and what did you do to take care of it?? Can I just use a really carefully placed small bead of silicone along there?? Thanks for the help!!!
Just be sure it is properly sealed, especially if you are using it in an F-body...dont ask me why I say that....
Thread Starter
TECH Enthusiast
iTrader: (2)
Joined: Aug 2008
Posts: 617
Likes: 0
From: Alberta, Canada
Thanks guys. Im new to this. I didnt realize that them seals are supposed to be in connectors. When the harness comes back I will put them in there.
Last edited by cutlass_455; Aug 22, 2008 at 11:35 PM. Reason: spelling error
Trending Topics
LS1 Tech Stories
The Best V8 Stories One Small Block at Time
6 Gifts Neither Your Dad Nor Grad Will Shove Into the 'Trinket Drawer'
Brett Foote
Topdon ONE vs. Artidiag 800 BT2: Which is the Diagnostic Tablet For You?
Pouria Savadkouei
Gas Monkey Built a 6-Wheel Ferrari Testarossa With a Corvette LT4 Engine
Verdad Gallardo
7 Most Reliable High-Performance Engines GM Has Ever Built
Verdad Gallardo
Amazing '71 Camaro Restomod Is Modern Muscle Car Under the Skin
Verdad Gallardo
6 Common C5 Corvette Failures and What's Involved In Repairing Them
Pouria Savadkouei
Retro Modern Bandit Pontiac Trans AM Comes With Burt Reynolds' Autograph
Verdad Gallardo
Top 10 Greatest Cadillac V Series Performance Models Ever, Ranked
Pouria Savadkouei
