Debadge

Reply Subscribe

Thread Tools

Search this Thread

Dec 23, 2010 | 11:25 AM

deviantvette

Thread Starter

Teching In

Joined: Jan 2009

Posts: 21

Likes: 0

Debadge

I would like to debadge my bird...take off the Trans am on the sides. Does anyone know if these are just attached with adhesive or if there are pegs and holes. I will not if there will be holes to fill.

Dec 23, 2010 | 11:56 AM

blk99transam

Staging Lane

iTrader: (1)

Joined: Nov 2005

Posts: 70

Likes: 0

From: Amarillo, TX

It's just adhesive, no holes to fill.

Dec 23, 2010 | 12:20 PM

Demonicbird00

10 Second Club

iTrader: (17)

Joined: Apr 2004

Posts: 2,409

Likes: 0

From: Alloway,NJ

yeah adhesive, make sure its warm out or use a heat gun. while your at it take the side molding off too

Dec 24, 2010 | 01:02 PM

beyonddisturbed

TECH Resident

iTrader: (5)

Joined: Dec 2009

Posts: 832

Likes: 1

From: Midwest

Quote:

Originally Posted by Demonicbird00

yeah adhesive, make sure its warm out or use a heat gun. while your at it take the side molding off too

This!

Dec 24, 2010 | 09:56 PM

94fixerTA

On The Tree

iTrader: (5)

Joined: Jul 2009

Posts: 173

Likes: 0

From: Fort Worth, TX

You heat up the molding if it's not hot outside already. The use a very thin wire or I used a skinny zip tie and heat the molding as you run the wire behind and pull it back. It should come off smooth. May leave some of the sticky residue an you can get a rubber wheel to put on a drill and wheel off the left over residue, but be sure to not push down hard or stay in one spot to long cause it can burn through the paint.

Last edited by 94fixerTA; Dec 24, 2010 at 09:58 PM. Reason: Added info

Reply Subscribe