New FAST Intake for LS7 or L92 Heads
#1
New FAST Intake for LS7 or L92 Heads
Just thought I would share this with everyone. Below is a copy of a email I sent to FAST asking about the production of a intake that would be compatable to the LS7 or L92 heads. I hope this isn't old news, its new to me.
Justin
We currently have a prototype on the dyno as I type. It's showing good
results already but we're not finished with it yet. Look for it at the SEMA
show later this year. Thanks for your interest in FAST products.
Jay Rohrback
Comp Performance Group
Ph. 734-341-6307
WWW.COMPPERFORMANCEGROUP.COM
Are there any plans to build a FAST intake that will accept the LS7 or L92
heads. If so any idea when the projected date for shipping would be?
Thanks,
Justin
Justin
We currently have a prototype on the dyno as I type. It's showing good
results already but we're not finished with it yet. Look for it at the SEMA
show later this year. Thanks for your interest in FAST products.
Jay Rohrback
Comp Performance Group
Ph. 734-341-6307
WWW.COMPPERFORMANCEGROUP.COM
Are there any plans to build a FAST intake that will accept the LS7 or L92
heads. If so any idea when the projected date for shipping would be?
Thanks,
Justin
#3
So they may not have a 92mm (or even the now older 90mm) intake available for the L92/LS3 (or LS7) heads until after SEMA 2008?!
Man they're going to lose A LOT of sales to the Starr/Weiand intake (supposed to be available for both rectangle and cathedral port heads right off the bat).
Man they're going to lose A LOT of sales to the Starr/Weiand intake (supposed to be available for both rectangle and cathedral port heads right off the bat).