6.2 Gen V LT1 A-body swap
#21
![Default](https://ls1tech.com/forums/images/icons/icon1.gif)
The offset WP is a eye sore and might be a limiting factor for some potential swappers. If someone made a kit that retrofitted a LS WP and added PS and made the mounts look like OEM ( This is were Holley should step up to the plate) I bet alot of peps would be gathering parts.
#24
![Default](https://ls1tech.com/forums/images/icons/icon1.gif)
Doug's Headers made custom set for me. They took the LT flange and put it on their A-body LS swap header. Hoping it will work, I should have the motor in permanently next week.
#31
![Default](https://ls1tech.com/forums/images/icons/icon1.gif)
someone that takes DD idea one step farther (OEM looking mounts) will sell alot of FEADS
#33
![Default](https://ls1tech.com/forums/images/icons/icon1.gif)
MZRICO,
Thanks for sharing. That looks ALOT better than the OEM FEAD
Thanks for sharing. That looks ALOT better than the OEM FEAD
#35
![Default](https://ls1tech.com/forums/images/icons/icon1.gif)
I like the more traditional look of the Dirty Dingo set up. The factory Gen V belt system is going to take some getting used to. Time will tell if the belt is going to be a problem.
#37
![Default](https://ls1tech.com/forums/images/icons/icon1.gif)
So what is everyone using for a cold air intake? I have the corvette manifold and throttle body, but the dirty dingo fead is in the way and the angle of the throttle body doesn't help either
#38
![Default](https://ls1tech.com/forums/images/icons/icon1.gif)
Holley is coming out with a TB to intake wedge to help this out . I think they are taking preorders.
#39
#40