When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
Just swapped in a t56 Magnum and have 2 gaping holes where the bellhousing meets the transmission. Is there a dust cover made for this? Or anyone have an alternative option to cover them if dust covers aren't made for it?
In actuality that hole is for a clutch fork application.... it actually helps remove heat from the clutch area and dust as well. I wouldn't worry about any debris getting in there unless you are doing some off roading. I remove all the plastic covers from that area in all of the swaps I've done.
In actuality that hole is for a clutch fork application.... it actually helps remove heat from the clutch area and dust as well. I wouldn't worry about any debris getting in there unless you are doing some off roading. I remove all the plastic covers from that area in all of the swaps I've done.
I noticed this also when I switched to the Moroso pan. I thought something was supposed to be there and started searching on t56 dust covers and found this post. Well that answers that question!
10-04-2016, 01:50 PM
T56 Magnum fbody spec dust covers? 
