Fullblast

iTrader: (17)

My fbody T56 needs a rebuild, but I came across a fresh rebuilt viper spec T56, so I'm getting that installed instead.

What exactly do I need to so it bolts up to the driveshaft?

Fullblast

iTrader: (17)

Heres a pic


Ok, this is definately a 30 spline tailshaft.

I've read on here that it needs a Viper 1350 yoke and a 1350-3R conversion u joint.


Does anyone know if these parts are correct or if i need anything else? Thanks

jmd

iTrader: (4)

Make sure your current driveline front U-joint measures as a 3R and that's right.

BALLSS

if you change to a 30 spline front DS yoke and a 1350 size.....do the same for the rear of DS also. You will also need to change the pinon yoke to 1350

Fullblast

iTrader: (17)

I ordered a 1350 ds yoke and a 1350 to a 3R, which is what my driveshaft is.

Why do you have to change the pinion and the rear of rhe driveshaft if im using a conversion u joint?

BALLSS

if you are using a conversion u joint, that works in terms of "bolting" it on