Category: Engine - Power Adders
Price: $12345678
Part Fits: 93-02 Chevrolet Camaro, 93-02 Pontiac Firebird
Location (State): AZ
Item Condition: Brand New
Shipping Information: Item Can be Shipped
Engine: LS2/LS3/LS7/L92/LS9, LS1/LS6
LS Engine?: Fits LS Engine

-Reverse rotation F1R is used and shows wear on the exterior of the case from being removed, reinstalled, wrenches bumping into it, etc. I verified it was rebuilt by Procharger just prior to me buying it. Previous owner got rid of it because of belt slip issues on a 12 rib. No troubles with this combo . Comes with cog drive hub and 40T cog installed. $1750 - SOLD

-Intercooler came off Mark Koehler's car. (2) of Garrett's new design 1500HP cores. It was painted before and had some of the paint sanded off to add gussets. This is how it was when I got it. I had it sandblasted in preparation for having it coated or Line-Xed. I also weld an additional mounting boss. 4" in, 4" out. $650

-Big Red Bypass is the open design. Brand new with all hardware and aluminum mounting flange. SOLD

All prices are + shipping and 3% paypal.

Thanks!

 

Can I get some more pics of the intercooler.

 

subscribing

 

PM me about the blower bracket setup and the bypass valve. I was just about to order this all from Dan.

 

Only had time for phone pics this morning... The 1/8th inch vac nipple is just sitting on top of the boss on top, LOL. There IS a small threaded boost port on the cold side as you'll see in the 2nd pic. Cooler is setup for dual -12 o-ring fittings in/out.

 

Bracket sold. Thanks!

 

Up

Consider trades on quality A2A intercooler, Holley HP EFI or cash ...

 

PMs replied. Bump

 

If the f1 is still avalible is it standard or reverse rotation? Please pm me for faster responce ... thanks!

 

Reverse rotation. PM'ed.

 

Ttt

 

Prices all dropped.

 

Dont see any water lines on the ic, are there any?

 

The reason is that the inlet lines are on the bottom of the near side tank and top of the far side tank (thus you can't see them). Configured this way to negate any air pockets. There are (2) -12 o-ring fitting on each side (4 in all). You can actually see the far side outlets in the first post with a little blue tape over them.

 

dam if the head unit was standard rotation it would no longer be in your hands and in mine !! bump for you ! if anybody has a f1r standard rotation pm me , i need one!! thanks

 

TTT. Lots of interest, but still available.

 

Up

 

Up for 'cooler and F1-R...

 

Still got the F1? Can you Email me the pics so I can see them on my phone..

Copeters@hotmail.com

 

The blower currently has a deposit on it.