F/S Cam Motion custom ground cam
234/240 .627 .641 112 lsa $325 shipped, less than 1000 miles on it. New combo coming, heads and intake are sold, cam and rockers are next. $215 shipped for the hs re-built rockers. Cost $260 to have them done plus shipping both ways. Buy mine and sell yours on ebay.

 

yes it ill work with stock heads

 

bump stick for sale

 

200 4 cam?

 

sorry thats to low, I'm always open to offers and would prefer them in a pm, thank you for the interest

 

Will this cam fit in a stock LS1 without fly cutting the pistons ?

 

I dont know for sure but I would say very doubtful. I have -2cc valve reliefs

 

rockers for sale as well as cam

 

t.t.t.

 

PM'd you. I will take the rockers, send me your paypal info please!!!

 

pm returned...

 

what kinda power did it make

 

what kind of power did what make? my car? or what power potential does the cam have? This a good cam for mid range to top end. Its not a 500 rwhp top end cam, it's 234 duration with hi lift. It produced a tabletop torque curve and peaked hp at around 6500 rpms with my setup. I have an extremely heavy drivetrain. 9" rear, twindisk steel flywheel and aftermarket 18x11 rims. In a 10 bolt with stock wheels its going to produce better numbers. On the street where it counts this thing was like a turbo. Once you hit 3000 rpms its a whole different animal. Has a nice lope, noticeable.

 

thanx im trying to see if it will require flycutting on stock heads and ill send you a pm

 

yes it will is my guess, I'd post up and ask in the internals section if I were you. I have -2cc valve reliefs

 

thats what im doing

 

rocker are sold pending payment

 

is there any advance in the cam