I am demodding my car and cleaning out the garage. I am selling due to an other priorities

I have a brand new 408 shortblock for sale. It is currently at Eagle Machine Shop getting machined, balanced, blueprinted, and assembled.

It consists of the following:
Brand New 6.0L Gm Iron Block - Being bored and honed to 4.030"
Callies 4" Crank
Callies 6.125" Compstar Rods
Diamond Pistons (You can pick the relief size)
Diamond Rings
New Cam Bearings
New Rod Bearings
New 3/4 groove Main Bearings
Completely assembled ready for you to slap your cam, heads and accessories on and go.

The motor will be ready to ship in 1-1/2 weeks. (Waiting on the pistons
Asking $4150 shipped.
(I will have it shipped directly from the machine shop so shipping will be cheaper.)

This is a brand new motor with high grade internals.

Misc. Performance Parts
Comp Cam 244/248 .617/.622 109+6----SOLD
Edelbrock RPM Nitrous Kit 4150 flange 10lb bottle w/ gauge, 75-250 jets, big solenoids good to 500 (plate only good to 300), w/heater and purge----SALE PENDING
NX Maximizer Progressive Controller----SALE PENDING

2004 2500 Chevy Pickup Parts
6.0L Truck Intake w/ FBW TB, injectors, and sensors----$100
6.0L truck power steering pump w/ bracket----$40
6.0L Truck Water pump----$30
Stock Pushrods----$15
Stock Cam----$15
Stock Timing Set----$15
Stock Balancer Pulley----$25
Front Timing Cover----$20
Rear Main Cover----$20

99' TA Parts--All parts are ebony

Complete Set of Seat Belts----$35
Nitrous Switch Panel For "Cubby" in TA----$30



A-Pillars----$25 per side



Door and Hatch Weather Stripping----$30



Center Console Auto---$85



Dash w/Air Bag (No cracks--DASH PAD and RADIO BEZEL SOLD)----$150



Complete Carpet w/ padding----$50



Prices do not include shipping. Check out my feedback.--This stuff is in good working condition..

 

Bump To The Top

 

How much for the T-top holders shipped to 21044?

 

PM Sent. Thanks

 

All PMs replied to.

 

pm sent

 

Does the Nitrous Switch Panel Replace the TCS switch area? or where exactly does it go?

 

Yes. Some cars don't have TCS so it goes in that "cubby" that is there. If you have TCS you can wire it into one of the switches.

 

List upaded and PMs replied to.

 

I need the plastic piece which snaps into the console. It's the piece the traction control switch mounts in to. I also need the driver side pillar if you still have it. Please PM me with your asking price and let me know, if you have these. Thanks.

 

Do you still have the console and lid?

Do you happen to have the auto shifter? Are the seats gone.

I didn't see them listed so I assume they are not for sale.

Thanks,

 

JEB99TA and Whittaker you both have PMs.

 

Hmm, I'm guessing the pending on the Maximizer is to someone else... regardless I sent you a PM on it, if the other sale falls through. Either way, let me know.

Thanks,

Blake

 

price on guages??

 

The pending on the maximizer and nitrous kit is JR Racing and he PMed me about it roughly a week ago but we were working out the details of the trade. I am very fair about putting people in line so if you feel that I skipped over you that is not the case.

 

No, not at all. Just wondered cause you hadn't responded to the PM.