468 fuel injection
#1
Teching In
Thread Starter
iTrader: (2)
Join Date: Aug 2011
Location: Northeast, Ks
Posts: 26
Likes: 0
Received 0 Likes
on
0 Posts
468 fuel injection
Ive got a 454 bored to 468 that we are running on alcohol in a pulling truck. It is currently set up with a carb. I have been trying to figure out the best route for fuel injection. So far it is a fully mechanical outside the ignition. Am trying to keep it as simple and preferably as cheap as I can. we are up around 1300hp. Any ideas?
#2
Have you looked into MegaSquirt? Is it a Mark IV, Gen V, or Gen VI? If it's a Gen VI you can look into EFI Connection's 58x, other than that you can look into Big Stuff 3 (beware BS3 is a little pricey). Also, what kind of RPM are you pulling with it?
#3
Teching In
Thread Starter
iTrader: (2)
Join Date: Aug 2011
Location: Northeast, Ks
Posts: 26
Likes: 0
Received 0 Likes
on
0 Posts
Honestly, Im not a big wiz on the 454 gens, my old man originally started with this engine in the 80's so its an older block design but nothing in or on the engine is factory. I have looked at the megasquirt a little but was a little leary about being able to get a kit together and working properly, the website just seemed a little vague. We are normally around 7500-8000 RPM kind of depends on the track.
#4
Honestly, Im not a big wiz on the 454 gens, my old man originally started with this engine in the 80's so its an older block design but nothing in or on the engine is factory. I have looked at the megasquirt a little but was a little leary about being able to get a kit together and working properly, the website just seemed a little vague. We are normally around 7500-8000 RPM kind of depends on the track.