Head gasket question
Thread Starter
Teching In
Joined: Feb 2008
Posts: 44
Likes: 0
Head gasket question Hello guys
I was wondering if any of you had use the Fel-Pro 1094 Head gasket http://store.summitracing.com/partde...4&autoview=sku
I have a 350 Chevy that the deck height is the orginal .025 and i have a dome pistons 8cc and a 70cc heads and if i would run this 1094 gasket would it be ok or would i lend in some piston to valve clerance issues, my pistons have a very large valve pocket but my valve lift is about 610". would it be a problem running this gasket, due to a piston to valve clerance issues?
Best regards Christian
I was wondering if any of you had use the Fel-Pro 1094 Head gasket http://store.summitracing.com/partde...4&autoview=sku
I have a 350 Chevy that the deck height is the orginal .025 and i have a dome pistons 8cc and a 70cc heads and if i would run this 1094 gasket would it be ok or would i lend in some piston to valve clerance issues, my pistons have a very large valve pocket but my valve lift is about 610". would it be a problem running this gasket, due to a piston to valve clerance issues?
Best regards Christian
Last edited by monzter; Feb 26, 2008 at 05:42 AM.
Nobody can accurately tell you whether or not you'll have ptv clearance issues, it's something you're going to need to check yourself. Odds are you'll be ok if there's decent valve reliefs in the pistons, but don't assume....measure it.
