VHT question?
Thread Starter
Staging Lane
Joined: Apr 2006
Posts: 62
Likes: 0
From: owasso
VHT question? when you spray vht track bite on the street do you need to light it or can you just leave it alone? and you see guys using it on the street do u need to mix it with anything for it to work right.
To use it in a pump sprayer and not end up clogging the lines, most people dilute it with a lil paint thinner, alcohol, soda 
,etc. It is more effective to apply several coats and light them individually. You can go out as far as 15-20 feet if they are higher power slick cars.
As far as using it on the tires, a small puddle in front of the each tire before the burnout will do just fine. Or "painting" it on each tire with a roller or brush beforehand is just as effective.
,etc. It is more effective to apply several coats and light them individually. You can go out as far as 15-20 feet if they are higher power slick cars. As far as using it on the tires, a small puddle in front of the each tire before the burnout will do just fine. Or "painting" it on each tire with a roller or brush beforehand is just as effective.
Put a small puddle behind the tire directly from the bottle. Roll back into it and do a healthy breaktand ..... proceed to burnout forward about ten feet. Roll back in your tracks to where your burnout was. do another small burnout to clean off the rocks on your tires from the roll forward.
Dump that bitch at 4k
Dump that bitch at 4k
