Tubular Kmember with subframes?
Thread Starter
Launching!
Joined: May 2009
Posts: 201
Likes: 0
Tubular Kmember with subframes? I bought some bmr tubular subframe connectors and I am fixing to install them. My question is, I want to put a tubular kmember with a arms and lower the car also. Will these extra mods effect the stance of my car and be working against the subframe connectors. I know the kmember will take off weight on the front, but will effect anything after the connectors are already on?
It will be the same as stock once you get it aligned. Thats alot of money and work to save 35lbs. I would wait till i had to pull the engine before i changed the k-member and a-arms.
I'm guessing if you are going that route you'll probably be putting on nice set of coil overs on also. You can adjust your stance from there. The only way a changed stance would effect SFC would be if you put a massive rake on the car and your clerance was compromised which I don't see happening.
SBC work well with a car no matter what k member you have in the car. Take a look at the link in my sig. I have pictures of a complete front clip from BMR on my car. I'm putting the SFC on tomorrow.
~Jim~
SBC work well with a car no matter what k member you have in the car. Take a look at the link in my sig. I have pictures of a complete front clip from BMR on my car. I'm putting the SFC on tomorrow.
~Jim~
No they will not be working against the SFC's. When installed a K-member and A-Arms it may change your stance slightly since you are cutting weight off the front end... but it is very minor. If you go with a coil over set-up you could then adjust the height of the front end.
If you have any other questions please ask. Also please consider UMI Performance for your front suspension purchase!
Thanks!
Ryan
If you have any other questions please ask. Also please consider UMI Performance for your front suspension purchase!
Thanks!
Ryan
