i know the tunnel mounted spohn t/a will clear all sorts of y pipes, but what about an x pipe? my car has a TSP Rumbler X and i'm not sure if it will clear it or stay off the ground with dms lowereing springs. - thanks

 

I have never see any type of X-pipe that cleared any type of cross member mounted TQ arm.

 

You would have to drop that x-pipe so low that it would be scraping the ground. I have looked at this (I have same x-pipe) and based on where my ds loop sits, I would need at least another inch of clearence. Not happening, especially on a lowered car.

 

i've seen it done a few different ways. one put the x pipe up in front of the trans crossmember and then split the pipes out wide around the torque arm crossmember.

this guy kept em close together on one side.

http://www.ls1camaro.net/freehosting/dsc00734.jpg

 

DAMNIT!! too bad i already have my friggin exhaust or i'd pull off someting cool like that guy ^. anyway, does anyone know of crossmember mounted tq arm that will clear a 3" x-pipe? appreciate the help