Sub-Frame Connector help
01-14-2007, 05:17 PM
#1
TECH Resident
Thread Starter
iTrader: (4)
Join Date: Jun 2006
Location: WYLIE, TEXAS
Posts: 916
Likes: 0
Received 0 Likes
on
0 Posts
Sub-Frame Connector help can you take BMR weld in subframe connectors and make them bolt in? How?
Because it cost to much to get them welded in
Because it cost to much to get them welded in
01-14-2007, 10:29 PM
#5
Teching In
Join Date: Jan 2007
Location: MOVING
Posts: 42
Likes: 0
Received 0 Likes
on
0 Posts
the only thing that i can think of ,would be some exhaust.fuel lines are a snap. no big deal. 70% of my work is undercar.If u have a pic send it and i can give u a more accurate explanation.(.2.or 3 point sfc)
Last edited by APSS; 01-14-2007 at 11:09 PM.
01-15-2007, 02:43 PM
#6
TECH Fanatic
iTrader: (32)
Join Date: Oct 2005
Location: Fairfax, Virginia
Posts: 1,687
Likes: 0
Received 0 Likes
on
0 Posts
Unless you are running true duals, nothing will be in the way. Direct bolt/weld in. The only thing that you have to take off is a plastic clamp over some wires on the drivers side. Oh yeah, and unbolt the rear LCAs.