Front wheelhub help
#1
Launching!
Thread Starter
iTrader: (17)
Join Date: Feb 2002
Location: Lake Zurich, IL
Posts: 221
Likes: 0
Received 0 Likes
on
0 Posts
Front wheelhub help
Does anyone know how to seperate the front axle hub from the bearing carrier? I'm sure that you start with the plastic end cap that houses the sensor connection. There are two notches on either side of the plastic cap, I'm sure they are for an expensive Kent/Moore tool. I'd guess the cap has to rotate somehow. Any ideas?
#3
Launching!
Thread Starter
iTrader: (17)
Join Date: Feb 2002
Location: Lake Zurich, IL
Posts: 221
Likes: 0
Received 0 Likes
on
0 Posts
Thanks. I mainly want to throw this in the blast cabinet, I didn't want to do it with the bearings installed. I didn't want to do anything with the cap until I knew it was ok to bang on it.
Thanks again-
Thanks again-