When I put the koni shock up into the wheel well to start to tighten, the "T" part at the bottom that bolts to the lower A-Arm doesn't sit QUITE flush, but the bolt goes through (with some persuasion), and I can get the nut on to tighten it... am I ******* something up or will it settle itself out with some weight on it? Thanks!

-J

EDIT: just put some weight on it and it's flush now. Question answered. Thanks.

 

Make sure you've got the mounting tabs pointed in the right direction. It should fit flush, but it's also possible you've got the lower A-arm out of position. If that's the case, you should be able to raise it (CAREFULLY) with a jack and get it to all fit flush. Remember, the spindle keeps the distance between the upper and lower A-arms correct, so if that's still out of wack, it might not fit flush.


-Mike

 

I'm too slow. Thanks Mike, I did that and it was a OK. Stock 115k mile stuff = the devil. I should buy stock in PB Blaster...