FS: old school engine stuff
Thread Starter
8 Sec Builder
Joined: Sep 2004
Posts: 80
Likes: 0
From: Houston Tx
FS: old school engine stuff Alright guys I got a fully machined 2 piece rear seal block thats at 4.030 bore, surfaced to 9.00, align honed. This block is a factory 4 bolt and comes with arp main studs. $300.
A comp cams cam for SBC 248/248 on a 110 valve lift w/1.5 = .525
Part #12-224-4 Grind # 294S for solid flat tappet or roller. Brand new $50
I also have some good ol 461 camel hump heads complete. The heads have been baked/blasted. They come with 2.02/1.60 manley valves, comp springs and retainers. These heads are ported and polished chambers also. They have custom valve angles and the chamber is I believe is 61cc. I have a complete flow sheet on these heads, the intake on average flow 248cfm, exhaust 178cfm. One problem with these heads is one intake port broke into water but is green deathed properly. $600 If you have any questions about any of this just pm me or stop by HPE. Thanks guys
A comp cams cam for SBC 248/248 on a 110 valve lift w/1.5 = .525
Part #12-224-4 Grind # 294S for solid flat tappet or roller. Brand new $50
I also have some good ol 461 camel hump heads complete. The heads have been baked/blasted. They come with 2.02/1.60 manley valves, comp springs and retainers. These heads are ported and polished chambers also. They have custom valve angles and the chamber is I believe is 61cc. I have a complete flow sheet on these heads, the intake on average flow 248cfm, exhaust 178cfm. One problem with these heads is one intake port broke into water but is green deathed properly. $600 If you have any questions about any of this just pm me or stop by HPE. Thanks guys
