LS1TECH - Camaro and Firebird Forum Discussion

Tools & Fabrication Hand | Power | Hydraulic | Pneumatic | Welding | Painting

tool to pull off TH400 speedo gear?

Thread Tools
 
Search this Thread
 
Old Aug 4, 2004 | 09:45 PM
Share
  #1  
Roadrunner 45's Avatar
Roadrunner 45
Thread Starter
TECH Enthusiast
iTrader: (1)
 
Joined: Oct 2002
Posts: 694
Likes: 0
From: Hawthorn Woods, IL
Default tool to pull off TH400 speedo gear?
my th400 came with a gear on the output shaft and I need to replace it with the reluctor & sensor setup. Anyone know of a good tool to pull off the gear with the trans still assembled?
Reply
0
Old Aug 4, 2004 | 10:37 PM
Share
  #2  
taqwache's Avatar
taqwache
10 Second Club
 
Joined: Jun 2002
Posts: 1,884
Likes: 4
From: H-town
Default
yes, a hammer. perferbly a small one. just make sure you take out that little clip first.
Reply
0
Old Aug 5, 2004 | 08:41 AM
Share
  #3  
Roadrunner 45's Avatar
Roadrunner 45
Thread Starter
TECH Enthusiast
iTrader: (1)
 
Joined: Oct 2002
Posts: 694
Likes: 0
From: Hawthorn Woods, IL
Default
How would you pull off the gear with a hammer? I'm not talking about the a gear in the side of teh case, I'm talking about the gear pressed on the output shaft.
Reply
0
Old Aug 5, 2004 | 07:45 PM
Share
  #4  
taqwache's Avatar
taqwache
10 Second Club
 
Joined: Jun 2002
Posts: 1,884
Likes: 4
From: H-town
Default
you just remove the tail shaft and lightly tap on it until it starts moving.
Reply
0
Old Aug 6, 2004 | 07:13 AM
Share
  #5  
Roadrunner 45's Avatar
Roadrunner 45
Thread Starter
TECH Enthusiast
iTrader: (1)
 
Joined: Oct 2002
Posts: 694
Likes: 0
From: Hawthorn Woods, IL
Default
I see- it must not be much of a press fit.
Reply
0
Tags
Back to Subforum
Tools & Fabrication
View Next Unread
SS Camaro - how much freon for AC?




Advanced Search

All times are GMT -5. The time now is 09:59 PM.