LSx header flanges?
Thread Starter
TECH Apprentice
Joined: Sep 2005
Posts: 370
Likes: 0
From: Port Charlotte, FL
LSx header flanges? I hope this is the right place- anybody know of a good source for stainless LSx header flanges and stainless tubing? I have been torn between keeping my Procharger or going turbo and am now kicking around just fabbing up a turbo kit (05 GTO). The fab work isn't a problem for me, but I just need a source for the materials. Thanks!
Joe
Joe
Thread Starter
TECH Apprentice
Joined: Sep 2005
Posts: 370
Likes: 0
From: Port Charlotte, FL
I found a couple of sources for mild steel so far, I'll check out Burns. Thanks!
I am also wondering if coated mild will suffice (used it in the past with good luck) or if I should just go stainless and be done. Chances are the setup would not be on the car for much more than a couple of years, so I think either will hold up as long as I'd need it to.
I am also wondering if coated mild will suffice (used it in the past with good luck) or if I should just go stainless and be done. Chances are the setup would not be on the car for much more than a couple of years, so I think either will hold up as long as I'd need it to.
Thread Starter
TECH Apprentice
Joined: Sep 2005
Posts: 370
Likes: 0
From: Port Charlotte, FL
Here is one place that has mild- http://www.forcedfab.com/product_inf...products_id=92
here is another- http://www.crateenginedepot.com/stor...30-P254C0.aspx
here is another- http://www.crateenginedepot.com/stor...30-P254C0.aspx
Thread Starter
TECH Apprentice
Joined: Sep 2005
Posts: 370
Likes: 0
From: Port Charlotte, FL
.
